How to set the battery percentage when adding ACE

The Yijia ACE mobile phone is a new Yijia model that has been launched recently. Its powerful configuration and low price have attracted many friends. Although this mobile phone carries a 5000mAh large battery, it will always run out. At this time, many friends like to set the battery power as a percentage display, which is obvious. How to set it?

How to display the power when adding ace

1. Open the [Settings] icon of the mobile phone and click the [Notification and Status Bar] option.

2. Turn on the switch on the right side of [Battery Percentage].

Introduction to 150W Flash Charging

The battery is full in 17 minutes, which is the power of 150W flash charge

According to the official data of Yijia Ace, the power of Yijia Ace can be fully charged in 17 minutes. I put the phone at 25 ° C, used an Ace original charging head and data cable for charging test, and counted the power of the device once a minute, with the initial power of 1%.

After charging for 1 minute, the power of Ace immediately rose to 11%, while it took only 7 minutes to charge 50%. At 17:06, the cell phone power value showed 100%. The test result was not different from the official data. For mobile phones with charging power less than 100 watts, it takes 30~40 minutes to fully charge.

The above is the specific method of setting the battery percentage with ACE. After setting, you can see how much power you have left! There is no need to be afraid that your mobile phone suddenly runs out of power. If you have other problems, please leave a message in the comment area!